|
THIEF ALERT
- Protects your outside property
- Sheds, Garages, Stables and Outbuildings are all vulnerable
-would you know if a thief was stealing your
property ??
- Many houses have alarms and cars are difficult
to steal, so thieves are now turning their attention
to unprotected buildings
- THIEF ALERT is a SILENT alarm which notifies you
when a thief is about
- The compact SENSOR unit is placed on the item to
be protected
- When the SENSOR is disturbed a radio signal is
sent to the ALARM unit
- The ALARM unit in the house sounds when the
sensor unit is moved
- Multiple sensors can be used for protecting
several buildings
SO YOU ARE IN CONTROL, YOU CAN :-
- Sound the optional external siren to frighten
the thief away or
- Carefully investigate yourself (perhaps with a
helper) or
- Phone the Police
THIEF ALERT PROVIDES THE FOLLOWING PROTECTION :-
- Sensor unit can be placed on high value item to
be protected
- Sensor unit can be mounted onto entry door frame
- Multiple sensors can be used with one ALARM unit
WHEN TRIGGERED THE FOLLOWING HAPPENS :-
- The sounder in the alarm unit sounds for 4
minutes
- The Alarm LED on the alarm unit starts flashing
and continues to flash until the alarm unit is
turned off, then back on.
- If the optional external siren is plugged in,
then it sounds for 4 minutes
BOTH SENSOR & ALARM UNITS ARE CONTROLLED BY A
SIMPLE KEY
THE STARTER PACK CONSISTS OF :-
- One Sensor unit & magnet (for optional door
mounting)
- One Alarm unit
- One Charger unit (for the alarm unit)
- Instruction Leaflet
Additional sensor units can be supplied for
additional protection as can external sirens or bell
boxes
OPERATING INSTRUCTIONS
Decide whether to simply place the sensor unit onto
the item to be protected or whether to mount it onto the
entry door frame. The sensor must be placed on a level
surface. If mounting onto a door frame firstly ensure
that the magnet can be mounted on the door so that it is
within 3 to 5mm of the side of the sensor with the reed
switch in it when the door is closed. Do not over
tighten fixing screws but ensure that there is not
excessive play. We recommend mounting on the hinge side
of the door. Please refer to the diagram in the
Instruction Leaflet supplied with the product.
Check that a PP3 battery has been fitted, do not use
a re-chargeable battery. Then switch the sensor on with
the key. Leave for 30 seconds to stabilize then move the
sensor, the red LED should briefly light showing that
movement has been detected. Leave the sensor switched
on.
Decide where to position the alarm unit in the house.
Plug the plug top power supply into a 13 A mains socket
and plug the flying lead into the 12V socket on the
alarm unit. Once the sensor unit has been switched on
for over 1 minute switch on the alarm unit with the key.
Now move the sensor unit (or open the door if mounted
on the door frame). The alarm unit sounder should now
sound for 4 minutes, or until you switch the alarm unit
off with the key. The red LED on the alarm unit should
flash until the alarm unit is turned off with the key.
|
